========================================================================================
Windows Device Driver for Intel(R) Server System SR2612UR Enclosure Services Devices
========================================================================================

This release note and the software that accompanies it are copyright (c) 2009, Intel Corporation or its suppliers, and may only be installed and used in accordance with the license that accompanies the software.

This Software is furnished under license and may only be used or copied in accordance with the terms of that license. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document. The Software is subject to change without notice, and should not be construed as a commitment by Intel Corporation or its suppliers to market, license, sell or support any product or technology. Unless otherwise provided for in the license under which this Software is provided, the Software is provided AS IS, with no warranties of any kind, express or implied. Except as expressly permitted by the Software license, neither Intel Corporation nor its suppliers assumes any responsibility or liability for any errors or inaccuracies that may appear herein. Except as expressly permitted by the Software license, no part of the Software may be reproduced, stored in a retrieval system, transmitted in any form, or distributed by any means without the express written consent of Intel Corporation.

INTRODUCTION
------------
The following files are contained in this directory:

 README.txt - This file
 NCSSES.inf - Windows Device Driver for Newisys Enclosure Services devices
 NCSSES.cat - Digital Signature for this device driver

INSTALLATION
------------
1. Attach the required subsystem to a Windows system

2. Boot the system and log in (with Administrator privileges)

3. The "Found New Hardware Wizard" should launch for each Enclosure Services Processor detected in each attached subsystem. For each of these, perform the following steps:
    a. Click "Next"
    b. Select "Search for a suitable driver ..." and click "Next"
    c. Choose the appropriate location selection option and click "Next" to allow the system to locate a suitable driver. Windows should report that it detected a suitable driver.
    d. Click "Next" to install this driver.
    e. Click "Finish" to complete the driver installation.

4. Launch the Device Manager (Control Panel, System, Hardware) to verify that the driver has been correctly loaded. It should appear under the "System devices" section as an "Enclosure Services Device".