This release note and the software that accompanies it are copyright (c) 2017, Intel Corporation or its suppliers, and may only be installed and used in accordance with the license that accompanies the software. This Software is furnished under license and may only be used or copied in accordance with the terms of that license. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document. The Software is subject to change without notice, and should not be construed as a commitment by Intel Corporation or its suppliers to market, license, sell or support any product or technology. Unless otherwise provided for in the license under which this Software is provided, the Software is provided AS IS, with no warranties of any kind, express or implied. Except as expressly permitted by the Software license, neither Intel Corporation nor its suppliers assumes any responsibility or liability for any errors or inaccuracies that may appear herein. Except as expressly permitted by the Software license, no part of the Software may be reproduced, stored in a retrieval system, transmitted in any form, or distributed by any means without the express written consent of Intel Corporation. This download supports Intel(R) RAID Controllers RMSP3JD160J, RSP3GD016J, RSP3QD160J. ================ Package Information ================ Package version: 3.00.02.01 (Phase 3) ================ Known Restrictions ================ Legacy OpROMs are not supported. Use UEFI mode only. ================ Known Bugs ================ N/A ================ Update Instructions ================ 1. Unzip all of the files from the zip package onto USB key, maintaining the directory structure. Please make sure that the USB key is fully compatible with the EFI version on your motherboard. Some incompatible versions may prevent USB key working normally. 2. Boot to the EFI shell - Press 'F2' during POST to enter BIOS Setup - Select Boot Manager -> EFI Shell 3. Change drive and directory location to where you unzipped the package by typing the following commands: fs0: cd Note: You can always get a list of files and sub-directories in the current directory by typing 'dir' command. Instead of 'fs0: you may need to type 'fs1:' or 'fs2:', etc. depending on your drive configuration and removable media type. 4. Type in the name of the batch file that matches your board model and press . rmsp3jd160j.nsh RMSP3JD160J with NVME & SATA/SAS support rsp3qd160j.nsh RSP3QD160J with NVME & SATA/SAS support rsp3gd016j.nsh RSP3GD016J with SATA/SAS support only Note: The batch files default to programming the first logical storage controller ("/c0" switch of the storcli.efi command). If the intended target is not the first enumerated Intel storage controller, modify the .nsh script to "/c1" (or "/c2", etc) to match. 5. Wait for the flash to complete. Do NOT reboot the system during the update. ================ Fixes/Updates ================ Package Version 03.00.02.01 1) NVMe & SAS/SATA auto detection added for RMSP3JD160J and RSP3QD160J 2) Mixed mode (simulataneous 8port SAS/SATA & 2port NVMe) support added for RMSP3JD160J and RSP3QD160J 2) Amber LEDs are supported with NVMe disks with RMSP3JD160J and RSP3QD160J. Package Version 02.00.05.05 1) This version is the initial release *Third-party trademarks are the property of their respective owners.